Sanitary return pump (self-priming pump)

Technical parameters:

application	Self-priming pumps are mainly used to transport some gas-containing materials. Therefore, they are widely used to absorb materials in various occasions where the liquid level is unstable or even lower than the pump inlet. They are also used as return in CIP systems.
Specification	5T-80T,2.2KW-15KW
Material	SUS316L (the pump body, pump cover, impeller and other parts in contact with the material are made of SUS316L stainless steel), the liquid seal material is EPDM ethylene propylene rubber.
standard	DIN, SMS
impeller	Louvered impeller
Surface treatment	The wetted parts are polished, the rest are matte or sandblasted
Shaft seal	The stationary ring of the mechanical seal is made of SUS316L steel with graphite embedded in it, while the dynamic ring is made of silicon carbide.
Maximum inlet pressure	0.5MPa
Temperature range	-10℃ to 120℃ (EPDM)

Motor

1. According to the configuration, it mainly adopts the high-efficiency M2BAX three-phase AC motor of the "ABB" brand, which is designed and manufactured according to the International Electrotechnical Commission IEC60034, IE60072 standards and meets the CE marking requirements of the European Community.

2. Explosion-proof motors can be selected to meet the needs of different occasions. 3.

Superior electrical performance, low noise, low vibration, the standard design protection level of the motor is IP55, and the insulation level is F class

4. Frequency: 50Hz/60Hz

5. Working mode: continuous (SI)

6. Speed: The speed of the standard pump is 1450r/min